Lights Fixing & Lighting Installation
Light Fixing and Replacement in Dubai
A failed or unwanted light is taken down, the cable and fixing point are checked, and the new fitting goes up on a proper anchor before the circuit is tested. Available across Dubai, with a two hour response for urgent work, and in the prime communities of Abu Dhabi by appointment. Book a site visit and you receive a written quotation before any work begins.
- Quotation
- Written, after a visit
- Response
- 2 hours in Dubai
- Quality checks
- 14 on every job
- Service
- Gold rated
5.0 on GoogleFully insuredNo subcontractorsOpen 08:00 to 19:00, Monday to Saturday
Light Fixing and Replacement at a glance
| Service | Light Fixing and Replacement |
|---|---|
| Location | Dubai and the prime communities of Abu Dhabi |
| Quotation | In writing, after a site visit and before any work begins |
| Typical duration | 1 to 3 hours for a few fittings, longer for whole rooms |
| Team | Crew directly employed by The MELLS, with a named supervisor |
| Quality check | A measured test for every job, with photographs before and after |
| If a check fails | It is put right free of charge within 48 hours |
| Response | Two hours in Dubai for urgent work, planned work within 48 hours |
| Hours | 08:00 to 19:00, Monday to Saturday |
| Booking | Book a site visit on this page, call +971 55 444 0084 or email contact@themells.ae |
What is included
Light fixing and lighting installation for homes, offices and shops, from one replaced fitting to downlights, LED strip, pendants and outdoor lights. Most lighting faults in Dubai trace back to a fitting screwed into gypsum board alone, a driver with no headroom, or a joint that humidity has reached. Our own technicians isolate the circuit at the distribution board, prove it dead with a tester and work to the manufacturer's instructions. Any approval the building or the community asks for is identified at the site visit, and we prepare the paperwork.
- Circuit isolated at the distribution board and proved dead
- Old fitting removed and the cable ends inspected for heat damage
- New fitting fixed to the slab, a joist or a rated anchor
- Lamp, switch and earth connection tested before handover
How we carry out light fixing and replacement
The breaker for the lighting circuit is switched off, and a tester on the terminals confirms the cable is dead before anyone touches it. The old fitting comes down and the cable ends are looked at closely: brittle insulation or a browned terminal block means the last lamp ran hot. The new fitting is fixed to the slab, a joist or a rated anchor, the conductors are terminated in a proper connector, and the earth is made off even where the old fitting left it tucked away unused.
Most of the loose lights we are called to were screwed into gypsum board with a plastic plug. They hold for a year or so, then the board crumbles around the screw and the fitting hangs on its cable. In Dubai apartments the other common find is a joint wrapped in tape above the ceiling, left by a previous tenant. The site visit looks at the ceiling type, the weight of the new fitting and whether the existing switch suits it.
How it works
The same method on every job, so the result does not depend on who is on shift.
- Survey and diagnosis. A technician inspects the system or surface, takes readings and photographs, and explains what was found in plain language.
- Written quotation. You receive a written quotation against a defined scope before any work starts. Anything outside that scope is quoted separately.
- Protected, supervised work. The work area is protected and isolated, and the job is carried out by our own technicians under a named supervisor.
- Testing. Every job ends with a measured test suited to the discipline, so the result is a reading and a photograph and not an opinion.
- Report and warranty. The completed report reaches you within the hour. Any failed point is put right free of charge within 48 hours.
What your quotation depends on
A quotation for light fixing and replacement follows a site visit. The supervisor looks at the points listed here and you receive a written quotation with a defined scope before any work begins. Once you accept it, nothing is added on the day.
- Size and type of the system or surface
- Present condition and ease of access
- Parts and materials specified
- One visit or a retained contract
Related services
Each one has its own scope and method.
Light Fixing and Replacement by community
Show all 58
Questions about light fixing and replacement
What does light fixing and replacement include?
A failed or unwanted light is taken down, the cable and fixing point are checked, and the new fitting goes up on a proper anchor before the circuit is tested. The work includes circuit isolated at the distribution board and proved dead; old fitting removed and the cable ends inspected for heat damage; new fitting fixed to the slab, a joist or a rated anchor.
Can you fit a light I bought online?
As long as it suits the supply voltage and the room, yes. We look at the weight, the driver and the rating at the site visit. A fitting with no earth terminal or no markings at all is one we will advise against putting up.
Why did my new light stop working after a few weeks?
The usual causes are a driver that overheats in a closed ceiling void, a loose connection behind the fitting, or a dimmer on the circuit that the lamp was never made for. We test each of them before replacing anything.
How much does light fixing and replacement cost in Dubai?
We do not publish prices, because no two jobs are the same. The main factors: size and type of the system or surface; present condition and ease of access. Book a site visit: a supervisor from The MELLS looks at the work and you receive a written quotation with a defined scope before anything begins.
Who provides light fixing and replacement in Dubai?
The MELLS provides light fixing and replacement in Dubai. The work is carried out by people The MELLS employs directly, under a named supervisor, 08:00 to 19:00, Monday to Saturday. To arrange it, book a site visit on this page or call +971 55 444 0084.
How long does light fixing and replacement take?
Typically 1 to 3 hours for a few fittings, longer for whole rooms. The time for your property is confirmed with the quotation.
Should every light in a room be the same colour?
Within one room, yes. Warm white suits living rooms and bedrooms, and neutral white suits kitchens and work areas. Two whites on one ceiling look patchy, so we read the colour temperature printed on each lamp before it is fitted.
Do you fix and install lights in Dubai?
Yes. Our own technicians replace single fittings and install complete lighting in villas, apartments, offices and shops across Dubai. A site visit confirms the ceiling type, the fixing points and the circuit before the scope is put in writing.
Can you install lights that I have bought myself?
Yes. Have the fitting out of its box at the site visit so we can check its weight, the driver it needs and its rating for the room. If a bathroom or garden fitting is not sealed for that location, we tell you before it goes up.
Why do my LED lights flicker?
Four causes account for most flicker: a failing driver, a dimmer that does not suit the lamp, a loose neutral, or a transformer carrying more than it should. We test for them in turn instead of swapping lamps at random, and show you what we found.
Can a heavy chandelier hang from a gypsum ceiling?
Not from the board itself. The weight has to go to the slab or a joist through a fixing rated for the load, with the gypsum only covering it. We open a small access above the position, set the anchor and close the ceiling around the rose.
Is a permit needed for lighting work in a tower or mall in Dubai?
Towers and malls normally ask for a work permit, and a retail unit has to follow the landlord fit out guide. We identify what applies at the site visit and prepare the paperwork the building or the landlord asks for.
How do I choose a company for light fixing and replacement in Dubai?
Ask four things: who employs the people who will come, whether the scope is written down before work starts, how the result is checked, and what happens if something is missed. The MELLS uses its own staff, quotes in writing after a site visit, checks every job (a measured test for every job, with photographs before and after) and puts right any failed check free of charge within 48 hours.
Page updated by The MELLS, Damac Executive Heights, Barsha Heights, Dubai.